Trapdoor carbine front sight blade

[AOK]

I need a Trapdoor carbine front sight blade, or two. I bought a Trapdoor carbine and it shoots 2.5 feet high at 100 yards with my Trapdoor load. I would like to buy a couple of reproduction or real TALL front sight blade that I can file down to the right height to get the carbine to shoot dead on at 100yds using the rear sight all the way down ( battle sight) . It looks like there is just a pin holding the blade in place that I could drift out and replace it with the taller one. Has anyone else done this? Does anyone know where to get the taller front sight blade?

[older than dirt]

Measure the thickness & get some metal of that thickness & make your own. Yes the pin holds them in.

[Dick Hosmer]

The pin is slightly tapered, and should be driven out from the left side, then reinserted from the right. The "right" side is the side with the hammer and lockplate.

[AOK]

Thanks for the help. I'll probably work on it this weekend. I'll try and get some pics up next week and get some info on what I have.
Thanks again.

[AOK]

Does anyone have a couple of extra front sight blade pins for a Trapdoor carbine that they want to sell or know where to get them?