Forum: The Reloading Bench

I am going to reload a couple hundred M2 Ball (30-06) cases, and I'm looking for a good way to remove the primer crimp. I tried to prime a case...

I just picked up a Webley 455 MkVI revolver that I'm looking for cases, dies, and bullets or a mould. Used items would be fine as I' not planning on...

Does any one know if accurate 2700 can be used safely in an m1? I just acquired an 8 pound jug and am running low on 4895.

I picked up a bunch of 1943 dated Rem. arms armor piercing ammo 30-06. I am pulling them down for the bullets, they are 165 gr.. It has about 49.5...

All I have now during the shortage are 124 gr. plated bullets. The P38 is a little anemic when compared to other pistols. Anyone see a problem...

I'm visiting here to talk about the 12ga From Hell and other developements it has led to.Nice site you folks have. I'm with a group of...

I have 1K or so I am going to sell or trade also a few hundred 6mm bullets some .45 230 FMJ's

Are there any alternatives to case lube? I lost my old tub and I swear, its being hoarded like everything else...... Could not find it any where,....

I recently bought some 45acp fired cases at gun shop. When I resized/deprimed them, the decap pin punched thru several opening the cap like a tin...

Anyone used Penn Bullets or Missouri Bullets lead 110 gr. bullets to reload .30 carbine? Results? Loads? There doesn't seem to be any loaded ammo on...

Any one have a pet load for their 25 06. Using 100 gr bullet with 52 gr of imr 4350 @ 3200 fps and can't get the thing to shoot under 2 1/2 min. Hate...

People have mixed feelings over Wolf and Tula primers. I have friends in competition, target shooting and hunting that either love them or hate...

Guys, Went up to the farm and found, among other things, three jugs of IMR 4895. They were never opened and appear to be tightly sealed. They were...

Curiosity has me asking if anybody has done enough bullet weight testing with weights from 155gr to 180gr to be able to say "The xxxweight bullet...

I've come into a bunch of FA 42 , .45 ACP cases. The primers are dead but they have not been fired. The primers are quite different from LG pistol...

I use a Dillon 650 for my short range .223 loads and was contemplating buying another progressive to load 30-06 on. Have any of you used BOTH...

Can someone inform me if it's known what the SAAMI cartridge headspace dimensions are. And is this cartridge's headspace measured off the...

Local gunshop is slowly getting restocked on things but small rifle primers are still hard to find. They have CCI BR but 500 limit. Stopped in today...

My loading buddy has picked up a few lbs. of TAC powder that we are thinking about using for 7.62x51 service rifle loads in our M1As. On the burn...

With shoulder problems shooting full house loads is just not possible, so for a time I didn't shoot my 30 caliber firearms. I happened to pick up an...

Gang, I used your advice to determine if my 8# jug of IMR 4895 is still good and it is. My buddy, Bob, is in need of some and I'm still recovering...

What were average prices for primers per thousand and a pound of powder before sandy hill i want to sell some to a young guy getting started at...