Dean's Gun Restoration
+ Reply to Thread
Results 1 to 4 of 4

Thread: GI barrel vise and receiver wrench drawings?

  1. #1
    Join Date
    Aug 2009
    Posts
    459

    Default GI barrel vise and receiver wrench drawings?

    Anyone have a copy of the Ordnance drawings for the barrel vise and receiver wrench used with the M1903?

    I know the receiver wrench drawing is RIA drawing number B31601 but I do not know the drawing number for the barrel vise.

    Thanks.

  2. #2
    Join Date
    Aug 2009
    Location
    Robertsdale, AL / Gulf Coast region
    Posts
    1,316

    Default

    I don't know if they are in here or not, take a look.

    http://www.jouster.com/forums/showth...mentional-data


    HTH,

    Emri
    Last edited by Emri; 09-10-2013 at 08:21.

  3. #3
    Join Date
    Aug 2009
    Posts
    459

    Default

    I'll have to spend some time tonight looking through that link. Lots of stuff! I know the reciever wrench drawing is in Brophys book but I do not have access to a copy.

  4. #4
    Join Date
    Sep 2009
    Location
    Denver Co
    Posts
    2,808

    Default

    neet,,,but nothing on the tools..
    i can tell you what they used at the factory is not the same as what they used at the repair level.
    my vise is a G.I. issue screw type barrel vise, i had to make the blocks..my action wrench is a beast at 50 pounds..
    id bet its the same type used to install 1917 barrels..very simple and basic.
    if it aint broke...fix it till it finally is.

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts